Products > Test Equipment

Rohde & Schwarz CMU200

<< < (27/71) > >>

CJay:
I have the Keysight 2017 software suite on a PCI based PC with a PCI GPIB card, I'm hopeful it will work with that.

CMU Base is 5.21

I'll dig out the PC and cables one evening next week and request a code, thank you for all your hard work.


cmu2017:
Thanks all for your answers.

@Vitor
Looks great :-)
But do I need also OPSW v5.x installed? You have this mention on your blog. But not here on your post

Bicurico:
OPSW v5.x is the DOS Software that runs on the CMU200 and CRTU.

I noticed that v3.x has only baud rates up o 19200, which is much too slow.
With v5.x you get 115200 baud, which is slow, but works.

Using the GPIB/USB interface you get 1.5MBit/s and thus you get a pretty fast refresh rate on the PC.

Regards,
Vitor

stan33:
Hi,
I have just bought one CMU200 that I will use using SCPI commands through the serial port only.
I have some troubles to use is as as simple spectrum analyzer. Is there a simple SCPI command sequence  to:
- set the display in max hold
- make a peak search and measure peak level/frequency ?
I am interested in doing this without getting arrays (if possible).
Thanks is someone can help.
Stan

markus_jlrb:
Stan,

you have to look for R&S doc for the CMU200
https://www.rohde-schwarz.com/de/suche_63238.html?term=cmu200

The remore seq. is looking like that one below:

set remote command mod. via menu ant then
send via RS232

1;INITiate:SPECtrum
...
sorry but for the middle part I have no example.
...

send to go back local mode
1;*GTL

Markus

PS.: There is a free software to control the cmu, you have to ask google.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod