Products > Test Equipment
Rohde & Schwarz CMU200
ZL1CVD:
..up to -100 - depends on setting, input port, etc...
Same for both CMU-RTU and CMU-200
ZL1CVD:
Better than -130 with span less than 1MHz & RBW 500Hz or less..
NavyBOFH:
I have seen the posts about the eBay link for the tracking generator add-on someone created - but has anyone given some real use and performance on it? I would like to know if it comes close to the other service monitors and spectrum analyzers I have used.
Sent from my iPhone using Tapatalk
Brainbox:
I own one and for me it does what I expect from it.
But how by heaven can I tell You if its meets the specs of Your other service monitors?
richnormand:
I have seen those, and opted for a different option that does not require opening up the modules and the CMU200.
I got one of the $25 eBay noise source from 1MHz to 3.5GHz. They are not all that flat but are handy for quick measurements. For example here are pics of my HP8561E with it's tracking generator HP84640A looking at the response of a lithium niobate SAW device. The other picture is the CMU200 using the noise source with the same device (but... do note the different dB/div and span between the two photos).
Quick and dirty but it works. All depends of what you want.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version