Products > Test Equipment
Rohde & Schwarz FPC1500 (FPC-COM2 kit) or Siglent?
RBBVNL9:
Should you decide to go the DIY route for the LISN, check out the project in the Elektor magazine recently: https://www.elektor.com/elektor-dual-dc-lisn-150-khz-200-mhz
pdenisowski:
--- Quote from: tautech on June 12, 2022, 01:03:14 am ---Does this mean the R&S has no preamp ? :-//
--- End quote ---
The R&S FPC does have an optional preamp (FPC-B22 option) which is included in the FPC-COM2 kit.
https://www.rohde-schwarz.com/us/products/test-and-measurement/benchtop-analyzers/rs-fpc-spectrum-analyzer_63493-542324.html
With the preamp on, sensitivity is increased to about -165 dBm (typ). We also spec TOI, SHI, and DANL with and without the preamp enabled.
pdenisowski:
--- Quote from: RBBVNL9 on June 11, 2022, 09:13:02 am --- Documentation is an aspect that often seems overlooked, but especially with such complex instruments as scopes and SA's I believe it is a really important aspect when purchasing new gear. [/li][/list]
--- End quote ---
For people who are new to the FPC (and spec ans in general), there are about a half dozen basic "Getting Started with the FPC" videos in the T&M Fundamentals Playlist on the R&S YouTube channel:
https://www.youtube.com/playlist?list=PLKxVoO5jUTlvsVtDcqrVn0ybqBVlLj2z8
--- Quote from: loki42 on June 12, 2022, 07:06:19 am ---Nice. I'm looking to get a lisn too for conducted EMC stuff.
--- End quote ---
There's also a video about LISNs (but probably too basic for you)
The next time I'm working on FPC-related videos, I'll do a few on EMI/EMC testing :)
nctnico:
The downside of the FPC1500 is that scalar measurements have a lower frequency of 2MHz. That is slightly high for dower power distribution network measurements. 100kHz would be nicer as a lowest frequency.
tautech:
--- Quote from: pdenisowski on June 12, 2022, 01:55:52 pm ---
--- Quote from: tautech on June 12, 2022, 01:03:14 am ---Does this mean the R&S has no preamp ? :-//
--- End quote ---
The R&S FPC does have an optional preamp (FPC-B22 option) which is included in the FPC-COM2 kit.
--- End quote ---
Oh thanks for clearing this up as the OP for his EMI needs should get the Tekprobe and preamp EMI set or purchase the B22 option and only the Tekprobe $199 EMI probes.
That certainly is an additional cost in getting the R&S whereas all Siglent SA/VNA's come equipped as standard with a preamp.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version