Products > Test Equipment
Rohde & Schwarz Oscilloscopes - Questions/Comments? Let me know!
<< < (42/75) > >>
Rich@RohdeScopesUSA:

--- Quote from: kwass on February 03, 2018, 05:14:24 pm ---Rich,

I've been using the UART decode quit a bit recently and came across a couple of things:

1) The Bus Table status does is not saved across reboots.  When the scope is started it always thinks that the bus table was last in the off mode.  It also does not remember the location/size of the table.

2) It would be a big help if the pattern trigger did not have to be at a fixed position in the frame, often you know the data you're looking for but not the position.  The single character trigger works to search anywhere in the data stream but it would be great if the pattern trigger would also.

Thanks,

--- End quote ---
Hi Katie,

Thanks - I'll pass these on.

-Rich
pulsewidthmodul:
Hi,

i just received my RTB2002 and i'm playing around with it to learn how to use it.

With the Videotrigger Option i may found a bug.
Trigger set to Video 720p, feeding a 720p Signal the scope triggers on falling edge of the Tri-Level Sync pulse, aacording to SMPTE 240M standard the trigger should be where the negative (-300mV) pulse goes to positive (+300mV.)
 
Or is it just me doing something wrong?

Thanks a lot

P
Rich@RohdeScopesUSA:

--- Quote from: pulsewidthmodul on February 05, 2018, 12:52:15 am ---Hi,

i just received my RTB2002 and i'm playing around with it to learn how to use it.

With the Videotrigger Option i may found a bug.
Trigger set to Video 720p, feeding a 720p Signal the scope triggers on falling edge of the Tri-Level Sync pulse, aacording to SMPTE 240M standard the trigger should be where the negative (-300mV) pulse goes to positive (+300mV.)
 
Or is it just me doing something wrong?

Thanks a lot

P

--- End quote ---
Hi - yes, it does appear to be a bug with the polarity.  R&D will get it fixed up.  Thanks.

-Rich
Ghislain:
Hi Rich,

Any new firmware updates for the RTB2000 series on the horizon?
pulsewidthmodul:

--- Quote from: Ghislain on February 10, 2018, 10:24:36 am ---Any new firmware updates for the RTB2000 series on the horizon?

--- End quote ---

anything new on this?
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod