Products > Test Equipment
Rohde & Schwarz RTO1024 upgrade ??
jjoonathan:
Here is mine. The temperatures are a bit higher than I'd like. I tried putting new thermal paste on the ADCs. Even though I did find dried out crusty old paste it must have still been doing its job because replacing it with new arctic silver didn't do shit (didn't affect fan speed OR temperature). It was also a big pain in the ass and involved playing chicken with those connectors that gave myhobo so much trouble. Would not recommend.
I suspect the solution to the high temperatures will involve poking some of the fan-related EEPROM constants.
@myhobo is the problem fixed?
myhobo:
my oscillioscope's 3 & 4 channel is not working. this is rtc1's log
jjoonathan:
Wow, it looks like none of the traces are connecting properly. Have you beeped them with a multimeter? Do they have DC connectivity?
myhobo:
Without power-on test, each is turned on, as if each pin is connected together.
myhobo:
Interface should be conductive
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version