Products > Test Equipment
Rohde & Schwarz RTO1024 upgrade ??
myhobo:
I have already run the install app as an administrator and stayed here. report error
jjoonathan:
Which RTO software version do you have?
TRN:
jjoonathan,
Thanks for updating the link, which is much appreciated!
Do you have any pictures of the frontend without the shielding/ heat-sink cover installed?
rgds
jjoonathan:
Nope, I didn't remove the front end shield. I've seen some marketing material with front-end relays visible and a few die shots but nothing great.
myhobo:
I downloaded the new firmware software from the R&S official website, the win7 version, the previous installation was successful. The night before, I used the service code 16052008f, entered the server 2 mode, clicked on the main flash, waited for a long time without response, then directly shut down, reboot Unable to use, after reinstalling the software, the operation will report the previous image error.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version