Products > Test Equipment

Rohde & Schwarz RTO1024 upgrade ??

<< < (15/24) > >>

jjoonathan:
I doubt that windows activation has anything to do with it, since we are seeing a bunch of errors that all have to do with Front End Controller communication. I have seen those particular errors before, although they never resulted in a hard reboot. They went away after the RTx.exe app successfully flashed the firmware, which did not happen until I ran RTx.exe with Administrator. You mention running the installer as Administrator, but it's not the installer that flashes the firmware, it's the RTx.exe app, the one that launches on startup and has a shortcut on the desktop (actually IIRC it's only the shortcut that is called "RTx.exe" and the actual app is "RTxLoader.exe" or something).

Have you tried running the app as Administrator?

Xavier64:
Some tricks and tipps for you guys on RTO1000 Series:


When you have FEC / FPGA Flash error etc. on first Firmware 3.70 start, exit the application and start over RtxLoader.exe as Administrator.

Flashing should be fine than... just be patient.


8GB RAM upgrade ONLY works on BIOS 1.01


You find the Flash tool in C:/Programfiles/Rohde Schwarz/3.70.xx/Tools/BIOS

Open a comandline cmd.exe as Administrator and Flash the RTO 1.01 file located in C:/Programfiles/Rohde Schwarz/Drivers


Than be happy with 8GB RAM :-)



dmendesf:
Thanks. I'm not with the scope now, will look later. This 1.01 is the CPU BIOS version, right? (The one we enter by pressing DEL at boot).

Xavier64:

--- Quote from: dmendesf on September 09, 2019, 03:20:13 pm ---Thanks. I'm not with the scope now, will look later. This 1.01 is the CPU BIOS version, right? (The one we enter by pressing DEL at boot).

--- End quote ---
YES Mainboard CPU bios we are talking about

dmendesf:
Thank you all. Fixed the scope. I entered safe mode, removed the RTx.exe from auto start, rebooted, run RTx.exe as Administrator, a few more upgrades and a reboot and it's working fine as you can see below. Just one strange nuisance remains: touchscreen mouse is upside down. When I run my finger from up to down the mouse goes up. Any more ideas?

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod