Products > Test Equipment

Rohde & Schwarz RTO1024 upgrade ??

<< < (18/24) > >>

myhobo:
Thank you, I have this file. I use SPI to program with a programmer, but it still fails to start normally. I suspect it is a problem with burning some address settings. I need the original file of your bios chip and you need to read it from the sst25vf016b chip.

jjoonathan:
Ah, that must have been the fie from the firmware then. Sorry, my bad! Here's the other one in my notes folder. These are the only two, so this should be it.

myhobo:
The rto1024 system can start again, but cannot run the oscilloscope software.

jjoonathan:
I'm glad to hear it's booting! I'll get you the mainboard EEPROM just as soon as I can open up my scope, but that probably won't be until the weekend.

myhobo:
jjoonathan, can you provide me this eeprom file? thanks

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod