EEVblog Electronics Community Forum

Products => Test Equipment => Topic started by: hafrse on February 04, 2019, 03:25:30 pm

Title: R&S FSH3 starts in Maintenance mode when attached to the power supply cable.
Post by: hafrse on February 04, 2019, 03:25:30 pm

Hello,

I have acquired a FSH3 , when inserting the power supply cable, it always automatically starts in Mainenance Mode and warms up in 60 min (counts down to 0 min ), nothong can be selected, keyboard is completely disabled, now If I press the power button, it starts normally.
This will not happen in battery mode. any clues how to get rid of the maintinance mode?

Thnaks
George