Products > Test Equipment

RS PRO / Siglent 1052DL+ stuck at boot logo.

<< < (7/14) > >>

malinda:
Hello I have the same problem with my RSDS 1052DL+... I get stuck at logo boot
From Sri Lanka

jtorregl:
Hello to everybody

I'm happy to read that the problem with my oscilloscope has solution.

In my case, I have a RSDS 1152CML+ (150 MHz) and it is brozen showing a screen with the RS PRO logo. I've tried the solution of the "Math button" but it didn't work.

I read in the forum that there is the posibility of reinstalling the software via USB or somethink like it. Please, don't hesitate to contact me and send me the files to try to fix the oscilloscope.

Thanks in advance.

Kit:
Hello everybody, my SIGLENT SDS1202X-E (buy it in december 2023) start up fine but any control doesn't works, several minutes later is working again.
math button trick not work at all. Please help me. Thank you.

Note: My house do not have earth connection (ground). This will can be a problem?. Excuse my poor english!!.

adam4521:

--- Quote from: Kit on February 14, 2024, 05:26:21 pm ---
Note: My house do not have earth connection (ground). This will can be a problem?.

--- End quote ---

Yes, you need to have that fixed. Check local codes but TT system, at least.

Kit:

--- Quote from: adam4521 on February 14, 2024, 06:19:28 pm ---
--- Quote from: Kit on February 14, 2024, 05:26:21 pm ---
Note: My house do not have earth connection (ground). This will can be a problem?.

--- End quote ---

Yes, you need to have that fixed. Check local codes but TT system, at least.

--- End quote ---

I used this oscilloscope in other place with earth connection and happens the same.  :-BROKE
Thank you.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod