Products > Test Equipment

RS PRO / Siglent 1052DL+ stuck at boot logo.

<< < (10/14) > >>

slawekmod:
Good morning.
Hello everyone. I have a problem with my Siglent 1072 CML+ oscilloscope.
The oscilloscope had not been used for two years. Today, after turning it on, it stopped at the Siglent logo. It does not respond to any buttons, the USB port for communication with the computer does not work. You cannot reset using the Math function.
The oscilloscope was used for approximately 100 hours.
Please help.
Sorry, I don't speak English and I use a translator.
Greetings from Poland.
Sławomir.

tautech:

--- Quote from: slawekmod on August 07, 2024, 07:16:16 pm ---Good morning.
Hello everyone. I have a problem with my Siglent 1072 CML+ oscilloscope.
The oscilloscope had not been used for two years. Today, after turning it on, it stopped at the Siglent logo. It does not respond to any buttons, the USB port for communication with the computer does not work. You cannot reset using the Math function.
The oscilloscope was used for approximately 100 hours.
Please help.
Sorry, I don't speak English and I use a translator.
Greetings from Poland.
Sławomir.

--- End quote ---
Welcome to the forum.

Check your messages.

slawekmod:
Hello
Yes, I received the message.
I replied to the email.
Thank you very much for help.
Regards.
Sławek

slawekmod:
Big thanks.
The oscilloscope works!
Thank you very much.
Regards.
Sławomir

Stestef89:
Hi everyone, I have the same problem on my RSDS 1102CML+ oscilloscope, freezed on the boot logo RSPRO.
I tried with math button but nothing change...
Someone can help me please?

Thanks in advance

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod