Products > Test Equipment
R&S RTB2004 Snooping
<< < (16/20) > >>
ElectronMan:

--- Quote from: tv84 on November 02, 2020, 04:53:53 pm ---
--- Quote from: ElectronMan on November 02, 2020, 03:24:05 pm ---The OTPData SCPI command appears to just write data to Block 0, Page 0. It does disable ECC before doing this, but I don't see it writing into the spare area.

--- End quote ---

Maybe you have to set the block/page with another command prior to read.

--- End quote ---

It is using the altera hwlib command. It takes care of that, but the first parameter is the START page/block and is set to 0. Technically it could be writing any number of pages, but it certainly looks like it starts at address 0.
uski:
FYI I tried decrypting the firmware for the RTM3000 series scopes with the same key and it didn't work. Meh.
ElectronMan:

--- Quote from: uski on November 07, 2020, 04:57:02 am ---FYI I tried decrypting the firmware for the RTM3000 series scopes with the same key and it didn't work. Meh.

--- End quote ---

Did you try this one?
https://www.eevblog.com/forum/testgear/rs-rtm2000-has-anybody-hacked-this-scope/msg3282494/#msg3282494
Harjit:
Wondering if anyone has updates? This was fascinating to follow along.
uski:
Hi


--- Quote from: ElectronMan on September 20, 2020, 07:23:19 pm ---

--- End quote ---

I am trying to identify the part number for a matching connector for the JTAG connector. Any idea ?
Pre-made cables would be even better but that's probably a stretch

Thanks
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod