| Products > Test Equipment |
| R&S to launch MXO5 |
| << < (14/30) > >> |
| Martin72:
:-DD |
| 2N3055:
--- Quote from: jjoonathan on October 31, 2023, 03:49:35 pm --- --- Quote from: 2N3055 on October 31, 2023, 03:14:11 pm ---Does this mean sample rate and datastreams are independent (two different data pumps and streams)? If that is so you could implement Frequency domain cross triggering. Now, that would be very nice... --- End quote --- I think the FFT is still operating downstream from the time domain acquisition so I don't think we can do that yet (at least not with high POI). I'd benefit greatly from being able to look at power/signal rails at low Fs and FFTs at high Fs, but I don't think the architecture supports this (yet?). You still have considerable freedom to adjust FFT settings on an acquisition -- wider RBW means you can fit more overlapped windows -- but I think they still need to fit in the time domain acquisition Fs/length, so you need to lengthen the time domain acquisition if you want small RBW and you need to store high frequency samples if you want a high max frequency in your FFT. R&S easily has the best FFTs given these constraints, but it is exactly because R&S makes RTSAs that operate on a gapless parallel stream (i.e. without these constraints) that hope springs eternal. While you're at it, could you bring back deep voice guy too ;D --- End quote --- There are options in addition to always running ADC that has two full BW streams, one going to, let's call it, SA engine, and other going to triggering and paging and then to time domain scope engine. They could pipe out data for SA after trigger engine (where it is still in full data rate) and before decimation. So you could have separate decimation and hence sample rate. I would still use same triggered blocks and route/decimate/process left and right. Less throughput needed that way. Basically use same ping-pong buffers just route them left and right. Also if triggering engine has such a low blind time, it could also simply copy time-domain /frequency domain block in time shared multiplexed fashion with same data pump... Interesting... |
| Sighound36:
Ok, it starts at 17K but what is the cost for an 8 channel 2Ghz model with three phase and power analysis options with two matching current probes and HVDP's |
| Sighound36:
Ok, it starts at 17K but what is the cost for an 8 channel 2Ghz model with three phase and power analysis options with three matching current probes and HVDP's |
| Martin72:
Batronix has already listed the new ones... 8-ch 2Ghz : https://www.batronix.com/versand/oszilloskope/Rohde-Schwarz-MXO5-820.html |
| Navigation |
| Message Index |
| Next page |
| Previous page |