Products > Test Equipment

RuiDeng Riden RD6006P DC power supply

<< < (4/10) > >>

duckduck:
Hey, UniSoft, I am working on a device file for the RD6006P for HKJ's wonderful testController PC software:


--- Quote from: HKJ on March 25, 2020, 10:48:51 am ---I have been working on a program that can log from multimeters, electronic loads, power supplies and some other stuff.
[...]

--- End quote ---

Would you happen to have any information on how the RD6006P differs from the plain old RD6006 when reading and writing via modbus? Ideally I'm looking for a reference like this ( https://github.com/msillano/RD6006-Super-power-supply/blob/master/RD6006_prtotocol_en.pdf ) which is for the plain old RD6006, but for the RD6006P. Thank you.

JorgH:
Flashed with UniSoft's firmware (Thanks for making great stuff!)
Screen seems to show artefacts and is rotated by 90 degrees.

My unit came shipped with V1.39 Firmware (v1.12 bootloader).
Everything is fine after flashing it back to stock v1.39.
Thoughts?

UniSoft:

--- Quote from: duckduck on July 02, 2021, 07:27:27 am ---Would you happen to have any information on how the RD6006P differs from the plain old RD6006 when reading and writing via modbus?

--- End quote ---
All the same...

UniSoft:

--- Quote from: JorgH on July 05, 2021, 10:46:46 am ---Flashed with UniSoft's firmware (Thanks for making great stuff!)
Screen seems to show artefacts and is rotated by 90 degrees.

My unit came shipped with V1.39 Firmware (v1.12 bootloader).
Everything is fine after flashing it back to stock v1.39.
Thoughts?

--- End quote ---
I think they use some new LCD display...
This also explains why they recently released new firmware for all models, and delete old version.
I will check, and fix it in next release.

SteveyG:

--- Quote from: UniSoft on February 22, 2021, 11:20:11 pm ---I drew a schematic of RD6006P... (Draft)
I drew it without removing the components from the PCB, so there may be for sure there are errors.
If you see anything, let me know, I can double-check certain parts of the circuit, until I assembled the power supply.

--- End quote ---

Great stuff. I will take a look through.
I did a review a while back, but I've not yet found any need for the additional accuracy, though given the price difference it's a no brainer to go for the precision model.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod