Products > Test Equipment
RuiDeng Riden RD6006P DC power supply
UniSoft:
--- Quote from: Sigi_cz on October 01, 2022, 12:54:27 am ---I plan to buy the RD6012P. Is there a list of features the UniSoft's FW adds for the RD6006P?
--- End quote ---
There is no list of features.
All features are described in a reference document.
RD60xx Custom Firmware Reference
Here you can download an official manual(s)...
http://www.ruidengkeji.com/inst/RD6006P.pdf
http://www.ruidengkeji.com/inst/RD6012P.pdf
Note: for RD6012P there is no custom firmware!
gljuk:
Hi!
Got RD6012P, the RD6006P's more powerful version.
Today started using it as usual, but found that output voltage could not be regulated. It is aporrox. Vin-1.2V. Vin is 20V, so the output is between 18 and 19V. Unit is on CC mode, although no load is connected.
The unit is like new, never used with loads higher than 5A. Seems that some transistor is shorted. How to find one?
Thanks
Alex
update:
It was all my fault. I have desoldered LED on the back of the unit, thinking it was just for indication. It was not! Soldered it back and the unit is working flawlessly. D'oh
Surgo:
I picked up and assembled an RD6006P kit. It came with an extra surface-mount component of some kind in a bag that I have no idea what is for. It wasn't mentioned at all in the assembly video on Riden's YouTube page, but it's in its own bag so I figure the inclusion isn't a mistake. Anyone have any idea what it's for?
electr_peter:
Most probably it is a SMD fuse replacement. There is a SMD type fuse holder on PCB.
myf:
Hello,
I recently purchased an rd6012p power supply and also received this tiny component in its little pouch.
The user manual can be found at http://ruidengkeji.com/inst/RD6012P.pdf
The photo on page 42 shows the inside of the device. On my device, the Q position (on this photo p.42) is empty (as on the photo). I leave this fuse holder empty and my device works.
I don't understand the comments about "less than 10A" for this fuse when the RD6012P is a power supply that goes up to 12A.
It seems that there is another fuse in position P. This additional fuse is perhaps a replacement for the fuse in position P.
I don't know...
Have a nice day !
F.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version