Products > Test Equipment
SainSmart DDS120 & DDS140 USB Oscilloscope
<< < (66/84) > >>
doctormord:
Nice, keep it up. :)
merbanan:
I took a picture of a 1kHz triangle wave. And it is easy to see here that I am missing every other buffer.
doctormord:
Hmm, isn't it async as well?

Nice one anyway. I wonder if "readbulkdata" is caring for the buffers itself. And what will happen, if you sample both channels, available buffer would half for each channel I guess.
merbanan:
I have now tested the sainsmarts bulk endpoint 0x86 and I could not get it working. I did get a sane transfer count when running the test120 application and using it in 2.4MHz and 2.4kHz mode. In both cases I got close to double Ms rate. But when choosing "50" MHz mode I max out at ca 7.5Ms/s.  Either the interrupt read is not working correctly with regards to some buffer handling or bulk reads are needed to be able to get more data. I am more and more convinced that a custom firmware is needed to get reliable data from the hardware.
doctormord:
Maybe it's a setup issue. Have you checked the other .dll functions? I'm not sure if they share the dll code for both the DDS120/140.

Have you had a look into the source of "leidioskop", it should be available here in the thread.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod