Products > Test Equipment

Sanwa PM300 Pocket Multimeter Review Teardown

<< < (7/8) > >>

EEVblog:

--- Quote from: MacMeter on September 30, 2017, 09:21:03 pm ---Received the PM300 today. Very NICE!
Wondering if it might be recommended to add a few drops of a flexible cement sealant on the ends of the probes where the wire enters the top of the probe as the wires go in loose and can easily twist and over time break off?

--- End quote ---

I noticed that when I first got it. I did some twisting tests and it didn't look like a problem. But users can do that if they want.

MacMeter:
Used GE Premium Silicone glue in tube. Could not get much down into hollow end of lead tube as glue is so thick, used a toothpick. Should be better then nothing.

NOTE: Could NOT attach an iPhone photo, “warning” says cannot attach JPEG extension, only JPG. Odd!

brian_stine:
Does anyone have instructions on how to calibrate the meter?  I don't want to send it to them and I have all the equipment to do it myself. 

whill44:
After Dave sent out an email about this particular meter being on sale I ordered one. I had already received the bm235 and it's better than advertised. I not only enjoy his videos but trust his opinion about such things, same with joe smith.

Thanks again.

brian_stine:
to enter Calibration mode:

(1) Hold down select and hold keys at same time.  (2) switch range to ACV (3) release 'select' and 'hold' keys after 5 seconds.  Meter enters calibration mode. 

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod