Products > Test Equipment

Scope waveforms "out of sync"

<< < (3/3)

pdenisowski:

--- Quote from: 2N3055 on October 24, 2023, 06:52:36 pm ---If you are using different probes (especially if one of them is active DIFF probe and other one is passive one) then both of these probes will have different propagation delay. Also if cables are not same length. Or using combination of voltage and current probes...

Proper scopes have Channel Deskew function in channel setup to compensate for that.

--- End quote ---

I was just about to say the same thing :)  Deskew fixtures and compensation exist -- even in mid to low range scopes -- for a reason.

If you're probing the same point with two identical voltage probes and see offset/skewed waveforms, I would definitely find that odd.

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod