Products > Test Equipment

SDG1032X refuses to upgrade

<< < (3/3)

coromonadalix:

--- Quote from: KungFuJosh on November 29, 2024, 04:22:06 pm ---Try the attached instead. I made a cleaned up version for something else, but this should work for you too.

--- End quote ---

Far from being complete, you miss many frequencies,   corrected a few

import hashlib

# SCOPEID?
SCOPEID = 'SDG1XCAC3R0567'
Model = 'SDG1000X'

to modify :
bwopt = ('30M','40M','60M','100M','120M','150M','200M','350M','500M','AWG','WIFI','MSO','FLX','CFD','I2S','1553','PWA','MANC','SENT','A429')


gives     and they are the same ??


30M   G4IP4FQQFE4RN2IH

60M   H2TGG25QPK97X3DS


PLS update your FW before anything else  and report back
now at   Version: V1.01.01.33R8      2024-04-18

KungFuJosh:

--- Quote from: coromonadalix on November 29, 2024, 05:42:06 pm ---Far from being complete, you miss many frequencies,   corrected a few

--- End quote ---

Well, yeah. I had set it up for the SDS2504X Plus. He figured that out on his own. 😉

tv84:
Since the 30M code is OK, then the problem MUST BE in the terminal that you are using to send the license string.

Make sure you don't have needless CR/LF in that thing!

coromonadalix:
usb the best  loll

mrehorst:
I updated the firmware to 1.01.01.33R8.
Tried again using MS telnet client and Putty.

Under new firmware, behavior has changed when I run either the MS telnet client or putty. When I send MCBD? the response comes back with >> overwriting the first two characters and the string looks like >>IP4FQQFE4RN2IH

I tried MCBD H2TGG25QPK97X3DS and then reboot and it still doesn't update to SDG1062X.

I'll see if I can get in via USB.




Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod