Products > Test Equipment

SDG1032X refuses to upgrade

(1/3) > >>

mrehorst:
Hi everyone.  I recently picked up a Siglent SDG1032X and have been trying to upgrade to the SDG1062X using the script found here https://www.eevblog.com/forum/testgear/siglent-sdg1000x-waveform-generators/msg4395403/#msg4395403.

The script runs, the 30M key matches my machine, I enter the 60M key then check and it still reports SDG1032X. I tried rebooting the SDG and it still reports SDG1032X.

My SDG software version is 1.01.01.33R1,  hardware is 02-01-00-24-00

Am I missing something?

Thanks!

coromonadalix:
try again with nothing in scope id ??

and have you rebooted  once you applied the mcbd xxxxxx serial ?


i have done so far 3 of them,  no problems


--------------------------------
Here are the bandwidth codes,  same as you  ??? 

but i used  the usb port, rhode schwartz visa drivers who contain tester tools to communicate, 32 and 64 bits included

30M   G4IP4FQQFE4RN2IH

60M   H2TGG25QPK97X3DS

i used the universal siglent keygen  from here, option 1 and 3,     and a different one,    same results  ???

mrehorst:
Yes, I reboot immediately after attempting to assign the new value using "MCBD H2TGG25QPK97X3DS"
When I set the scopeid to "", the 30M value returned doesn't match the number returned by the AWG when I run "MCBD?".
It seems odd that different serial numbers would generate the same 30M and 60M codes.

Hmmm.

tv84:

--- Quote from: mrehorst on November 29, 2024, 02:31:09 pm ---It seems odd that different serial numbers would generate the same 30M and 60M codes.

--- End quote ---

They don't. Each S/N has its own codes.

When you reach the point of being able to recreate the MCBD? response, you will able to generate any new valid code.

coromonadalix:
you need the 30m  to match 1st as you guessed in the generated codes ...     there was at some point  scope scripts and gens scripts  ... confusions,   i was  loll

if not the 60m upgrade will not work, since it will not be valid as an sn upgrade

MCBD?  should give you the infos,  as tv84 wrote

since any equipment has its own SN, and ID  no given codes of others  unlocked ones  will work

try with USB connection ...

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod