Products > Test Equipment
SDS 1072 CML + won't boot up
hakatu:
Hi guys,
I have a Siglent SDS 1072 CML+ that was working normally until yesterday. It stucks at the Siglent/Siglent Technologies logo indefinitely. I tried the Math button for hard reset but it doesn't work.
This model has a USB B and RJ45 port at the back, is there anyway to recover the DSO base on those ports?
Thank you in advance.
tautech:
--- Quote from: hakatu on November 22, 2023, 01:04:35 am ---Hi guys,
I have a Siglent SDS 1072 CML+ that was working normally until yesterday. It stucks at the Siglent/Siglent Technologies logo indefinitely. I tried the Math button for hard reset but it doesn't work.
This model has a USB B and RJ45 port at the back, is there anyway to recover the DSO base on those ports?
--- End quote ---
Welcome to the forum.
NO, under any circumstances, no !
Send PM with your email for our USB A recovery tools.
hakatu:
--- Quote from: tautech on November 22, 2023, 01:10:09 am ---
--- Quote from: hakatu on November 22, 2023, 01:04:35 am ---Hi guys,
I have a Siglent SDS 1072 CML+ that was working normally until yesterday. It stucks at the Siglent/Siglent Technologies logo indefinitely. I tried the Math button for hard reset but it doesn't work.
This model has a USB B and RJ45 port at the back, is there anyway to recover the DSO base on those ports?
--- End quote ---
Welcome to the forum.
NO, under any circumstances, no !
Send PM with your email for our USB A recovery tools.
--- End quote ---
Thank you for the warning. I sent you the PM for the tools.
tautech:
--- Quote from: hakatu on November 22, 2023, 01:52:49 am ---
--- Quote from: tautech on November 22, 2023, 01:10:09 am ---
--- Quote from: hakatu on November 22, 2023, 01:04:35 am ---Hi guys,
I have a Siglent SDS 1072 CML+ that was working normally until yesterday. It stucks at the Siglent/Siglent Technologies logo indefinitely. I tried the Math button for hard reset but it doesn't work.
This model has a USB B and RJ45 port at the back, is there anyway to recover the DSO base on those ports?
--- End quote ---
Welcome to the forum.
NO, under any circumstances, no !
Send PM with your email for our USB A recovery tools.
--- End quote ---
Thank you for the warning. I sent you the PM for the tools.
--- End quote ---
Replied via your email.
hakatu:
Thank you so much, it is now working normally
Navigation
[0] Message Index
[#] Next page
Go to full version