Products > Test Equipment
SDS800X HD Wanted Features
ebastler:
--- Quote from: Performa01 on April 23, 2024, 06:08:27 am ---Since display modes have to be implemented in hardware, an additional mode would take additional resources that (if at all available) would be much better spent elsewhere.
--- End quote ---
I can certainly acknowledge that point. Engineering resources are limited, and if the change would be too "expensive" for what it delivers, it will not make the cut. I think that is the better way to look at it, rather than going round in circles debating whether there are use cases which would benefit from "scan mode".
electronics hobbyist:
--- Quote from: eTobey on April 23, 2024, 06:21:26 am ---I just turned on the scope this morning to see, that all my trigger settings were lost
--- End quote ---
What trigger type it before shutting down, and what trigger it when it turned on today? If the plug is directly unplugged, this problem may occur. If not, it may be another problem.
I haven't encountered the problem you mentioned yet, I shutting down normally(Utility - Shutdown or Press the power button for 2 seconds).
mawyatt:
A nice feature for all the Siglent DSOs that support Bode Plots and Math Functions would be to allow the DUT Input and Output selections to support not only Channels 1-4 but also the Math Function. With this added capability using the Bode Plots for Impedance and Admittance measurements/plots becomes more straight forward without the need for additional support equipment such as Current/Differential Probes.
For example, one could use the Math function to subtract the voltage probed across a Reference Resistor with a pair of Channels to use as the DUT current for the Bode Plot.
Best,
eTobey:
--- Quote from: electronics hobbyist on April 23, 2024, 07:00:51 am ---
--- Quote from: eTobey on April 23, 2024, 06:21:26 am ---I just turned on the scope this morning to see, that all my trigger settings were lost
--- End quote ---
What trigger type it before shutting down, and what trigger it when it turned on today? If the plug is directly unplugged, this problem may occur. If not, it may be another problem.
I haven't encountered the problem you mentioned yet, I shutting down normally(Utility - Shutdown or Press the power button for 2 seconds).
--- End quote ---
If i remember this right, there are many places where setting got lost from triggers:
- Delay trigger
- Qualified trigger
- levels of inactive channels on edge.
I guess there are many settings more. Also there was this case, where the setting of edge trigger influenced the behaviour of i think it was qualified trigger.
eTobey:
Feature idea:
I am now at a position, where i would wish i could do the following:
Use the *measured* level of C1, together with the *measured* PWM pulsewidth of C2, and plot a x/y graph, with a series of measures of those values.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version