Products > Test Equipment

Seaward Sceptre EMC measurement system

<< < (5/5)

Pauldg1:
Hi,

I have collected a brand new complete unused old Spectrum analyzer from Seaward, type SCEPTRE 219A910.
The device works fine. The Sceptre software works with RS232 cable 1 to 1 (rx to rx, tx to tx, gnd to gnd).

The only point is that the software I have, Sceptre V2.03 is very limited. Is there a newer software available by someone?

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod