EEVblog Electronics Community Forum
Products => Test Equipment => Topic started by: Taviman on March 25, 2023, 04:51:06 am
-
Hey there!
(https://frankfurt.apollo.olxcdn.com/v1/files/7s01gpardt8b2-RO/image;s=1000x750)
(https://frankfurt.apollo.olxcdn.com/v1/files/p5zo2fxjz5fs-RO/image;s=750x1000;r=90)
I just purchased this power supply and the big G doesn't know much about it, outside some general data:
Triple Output
* DUAL Voltage, Ampere: DC+30V/3A, DC-30V/3A.
* Fixed Voltage, Ampere: DC 5V/2A.
Output: on / off control
Key Lock: key lock to avoid error operation
Protection: overload voltage, ampere protection: (SMPS)
protect over-heat and overload
CC, CV Set: auto set
Tracking: auto tracking
14-bit Programming and the voltage, the read back of the current.
Anyway, it has RS232 and I would be interested in controlling it via USB, the interface is a bit clunky
I don't have experience with GPIB, but I'm curious if there's a general solution available
Does anyone has any proprietary software? My FW is 8.06
What is this Seintek brand?
BTW, the PS works great, it even has current limit in 5V output