Products > Test Equipment
Sencore LC102 Display Shows "Short"
(1/1)
ScottSerpa:
I have an LC102 that I purchased new many many moons ago.  I think I had it calibrated once by Sencore but other than that one time, it's been working fine.  All of a sudden the display reads "Short" when testing a capacitor or zeroing "Open".  I found L1 stuck, replaced it but that made no difference.  I read 51 Ohms at the BNC so it's not an input short.
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod