| Products > Test Equipment |
| Show the homemade equipment you are using now. |
| << < (19/22) > >> |
| Ground_Loop:
My Unisolder with Pace Accudrive handle that I use almost exclusively. |
| tomud:
Vacuum pick and place tool controlled by a foot switch. Electronics built from what I had in stock (universal board, AT Mega microcontroller, etc.). It has several operating modes, adjustable pump speed, valve opening time, etc. |
| MiroS:
--- Quote from: MrYakimovYA on January 28, 2023, 07:25:42 am ---A bit of horror is inside. --- End quote --- I fully agree. |
| tomud:
--- Quote from: Kosmic on February 05, 2023, 02:14:02 pm --- --- Quote from: tomud on February 05, 2023, 12:45:57 am ---My old case design for Chinese 150W Constant Current Electronic Load 60V 10A ... --- End quote --- Mighty good job with the enclosure, I'm impressed :-+ --- End quote --- Thank you for the kind words. I'm not an expert in designing in CAD programs, just an electronics engineer and a programmer. But I try to do projects for a 3D printer as best as I can and I'm still learning. |
| Mickle T.:
A portable DCV/DCI/OHMs programmable standard (left) for the "Russian Cal Club" and an upcoming desktop version for home use (right). Both are powered by selected AD5791+LM399 after 5.2 years of electrical/thermal training. |
| Navigation |
| Message Index |
| Next page |
| Previous page |