Products > Test Equipment

Show the homemade equipment you are using now.

<< < (19/22) > >>

Ground_Loop:
My Unisolder with Pace Accudrive handle that I use almost exclusively.

tomud:
Vacuum pick and place tool controlled by a foot switch.

Electronics built from what I had in stock (universal board, AT Mega microcontroller, etc.). It has several operating modes, adjustable pump speed, valve opening time, etc.



MiroS:

--- Quote from: MrYakimovYA on January 28, 2023, 07:25:42 am ---A bit of horror is inside.

--- End quote ---

I fully agree.

tomud:

--- Quote from: Kosmic on February 05, 2023, 02:14:02 pm ---
--- Quote from: tomud on February 05, 2023, 12:45:57 am ---My old case design for Chinese 150W Constant Current Electronic Load 60V 10A
...

--- End quote ---

Mighty good job with the enclosure, I'm impressed  :-+

--- End quote ---

Thank you for the kind words. I'm not an expert in designing in CAD programs, just an electronics engineer and a programmer. But I try to do projects for a 3D printer as best as I can and I'm still learning.

Mickle T.:
A portable DCV/DCI/OHMs programmable standard (left) for the "Russian Cal Club" and an upcoming desktop version for home use (right). Both are powered by selected AD5791+LM399 after 5.2 years of electrical/thermal training.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod