| Products > Test Equipment |
| Show us your noise floor |
| (1/3) > >> |
| Jay_Diddy_B:
Hi group, The recent introduction of the Keysight HD3 series of oscilloscopes has prompted a discussion on noise floor. Please share your oscilloscope's noise floor here. To get this started: Tektronix MSO46 4-BW-500 Sample mode, full bandwidth, 1mV/div Hi-Res Mode 1mV/div Hi-Res Mode 5mV/div Regards, Jay_Diddy_B |
| Jay_Diddy_B:
Hi, adding to the thread Tektronix MSO24 2-BW-500 This scope does not have an internal 50 \$\Omega\$ termination. This is with input open. And with the high-res mode turned on: Regards, Jay_Diddy_B |
| Jay_Diddy_B:
Hi, Tektronix MDO4104-3 1 GHz scope And with the high-res mode on: Regards, Jay_Diddy_B |
| Jay_Diddy_B:
Hi, Agilent DSO-X 3034A (with BW50 500 MHz option) And with the high resolution turned on: I have run out of scopes. Please share yours :D Regards, Jay_Diddy_B |
| sonpul:
Siglent SDS1202X-E |
| Navigation |
| Message Index |
| Next page |