Products > Test Equipment

Show us your square wave

<< < (43/109) > >>

TunerSandwich:




 :-DD

TunerSandwich:

--- Quote from: T3sl4co1l on January 23, 2015, 11:16:09 pm ---And those frequencies are due to the wire, you say?

--- End quote ---

? that's at 10mV?  I doubt the wire is doing anything, other than acting as an antenna.....the pulse is buried in there somewhere.....

TunerSandwich:
now watch what this wire does, as the power increases......this is 1Mohm termination.....the resistance wire is pretty closely matched to 4ohm per conductor (you can see in the waveform).



TunerSandwich:

TunerSandwich:
Here is the Titanium resistance wire my company makes....it contains no iron, nickel, manganese, chromium or aluminum/copper.  These conductors are matched to 2.5 ohms each. 

Same setting on the sigGen, same 1Mohm termination



Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod