Products > Test Equipment

Show us your square wave

<< < (66/109) > >>

Howardlong:
What's the prototyping board you're using?

capt bullshot:
This is a SP3T-50x50-G from BusBoard Prototype Systems. It has a copper plane on the bottom side, 50x50 mils pads on the top side and non-plated holes every fifth pad or so. It is a thin PCB, can be cut using a paper scissor.

 

jpb:
I've been using the LTC6957 demo board. Unfortunately I'm in the middle of moving house (again) so everything is packed up so can't show anything other than this very bad photo.

The rise times for LVCMOS output is around 700 to 800 psecs and much less for the LVPECL version.

http://www.linear.com/product/LTC6957-1

Howardlong:

--- Quote from: capt bullshot on February 02, 2017, 07:00:56 pm ---This is a SP3T-50x50-G from BusBoard Prototype Systems. It has a copper plane on the bottom side, 50x50 mils pads on the top side and non-plated holes every fifth pad or so. It is a thin PCB, can be cut using a paper scissor.

--- End quote ---

Very nice, I'm sure I'll be adding a couple of those onto my next Mouser order.

Edit: do they spec the Er?

capt bullshot:

--- Quote from: Howardlong on February 02, 2017, 10:42:13 pm ---Edit: do they spec the Er?

--- End quote ---
No, afaik

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod