Siglent 1052DL+

[AdrianFu]

Recently I did a firmware update on my 1052 which then upgraded the model to a 1202(?). Not in front of the DSO right now. Not happy with it has it causes the DSO to run slow eg changing voltage level from say 1v/DIV to 10v/DIV can take up to a minute for anything to happen. Is it possible to back pedal back to the original firmware?

Adrian

[tautech]

Recently I did a firmware update on my 1052 which then upgraded the model to a 1202(?).

1202(?) ?? 
Never been such a model.
Where did you source the firmware from ?

Not in front of the DSO right now. Not happy with it has it causes the DSO to run slow eg changing voltage level from say 1v/DIV to 10v/DIV can take up to a minute for anything to happen. Is it possible to back pedal back to the original firmware?

SDS1000DL+ firmware page:
https://int.siglent.com/download/firmwares/?ProId=42

[AdrianFu]

I downloaded the firmware from that site. This is what happened after updating the firmware.

Adrian

[AdrianFu]

A better picture

Adrian

[tautech]

A better picture

Adrian

WOW, a 200 MHz DL+ ! 

I'll drop tech support a line for you.

[AdrianFu]

Thanks. Appreciated

Adrian

[tv84]

Is it possible to back pedal back to the original firmware?

If you want to downgrade the BW, send me a pm.

[AdrianFu]

All good thanks TV84. Now (hopefully) back to normal.
Should have asked the question about the firmware upgrade before I did it

Adrian