Products > Test Equipment

SIGLENT 3045 Remote EasyDMM Logging Issue?

(1/1)

sbeckert:
Wondering if anyone else has seen this remote logging issue using EasyDMM s/w?

When collecting remote measurements using EasyDMM (USB or LAN) I've found that Manual sample rate settings (tried fast to very slow) return duplicate readings about every 5-15 readings. The time increment increases normally but the reading is idential to the previous reading. When I go to Auto mode, which samples about 5sa/sec, the problem seems to disappear.

I've attached a pix what a clean sine wave input to the DMM produces when using Manual sampling in EasyDMM.

Anyone else seen this?

Thanks - Scott

KungFuJosh:
I don't like EasyDMM. You should check out TestController which is free and made by a member of this site. https://lygte-info.dk/project/TestControllerIntro%20UK.html

There's a small learning curve, but it's far superior to EasyDMM.

sbeckert:
Thanks - I'll take a look at it. Scott

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod