| Products > Test Equipment |
| Siglent .ads firmware file format |
| << < (73/85) > >> |
| alexitaly:
--- Quote from: tv84 on April 26, 2020, 07:50:47 pm ---I don't know who I'm helping anymore... :) I said 5.01.02.32 and you show a printscreen with 5.01.02.13 ? ? --- End quote --- Hi tv84, thanks for your help. --- Quote from: alexitaly ---I have problems with my ATTEN ADS1102CAL oscilloscope. The revision of the motherboard is SAT7.820.681H. The memory is 40k. Due to several bugs with trigger and time base I've installed the firmware of the SIGLENT SDS1102CNL oscilloscope: version 5.01.02.13 file SDS1000CNL_SSP_V100R005B01D02P13 I also tried the last one (32). --- End quote --- Unfortunately, my problem is also present in the last firmware release 5.01.02.32. In fact, the first attempt was to downgrade the firmware to the 5.01.02.13 release, and the problem was not resolved. Because of this i would like to downgrade to the ATTEN 3.01.01.31.16 release. I think, however I am not sure, that my problem is connected to the absence of 2M memory: I am trying to understand if this problem is due to some filtering algorithm to save memory... I'd like to know what you think about it. Thanks. |
| vtwin@cox.net:
--- Quote from: tv84 on April 26, 2020, 07:50:47 pm ---I don't know who I'm helping anymore... :) --- End quote --- How's that saying go... you can lead a horse to water? :) |
| routerfan:
Hello tv84, version 5.01.02.32 I have tried, it is invalid. It is an attempt to update the WaveAce firmware when it cannot be recovered after a fault occurs, but it still fails. There is a phenomenon in the middle that deserves attention. Before the fault, the channel calibration time is less than 20 seconds, but now it takes more than 5 minutes. . I guess whether the internal calibration data was damaged due to the chaotic flashing. |
| routerfan:
It's too clever. The hardware version and model of our oscilloscope are basically the same, not even the serial number. Of course, this was before I did not break my oscilloscope. |
| routerfan:
I have done everything from SIGLENT to atten, only to remove the memory chip and use the programmer. The premise is that you have the correct full dump flash file. The risk is high. I am an example of failure. Now look everywhere for the bin brush file suitable for my oscilloscope |
| Navigation |
| Message Index |
| Next page |
| Previous page |