| Products > Test Equipment |
| Siglent .ads firmware file format |
| << < (75/85) > >> |
| Elasia:
Also scored this... now i can calibrate my wave gen lol Python Scripts for SDG NOTICE 1. All scripts can only be used for calibrating SDG products. 2. Updating SDG’s firmware to the newest version is strongly recommended. 3. Before being calibrated, all devices should have been operating continuously for more than 30 minutes within specified operating temperature range (18℃ ~ 28℃) 4. Make sure all devices are well connected as section 1.3 shows. 5. Don’t open Microsoft Office Excel when running scripts. |
| tautech:
--- Quote from: Elasia on June 18, 2020, 10:39:59 pm ---Also scored this... now i can calibrate my wave gen lol Python Scripts for SDG NOTICE 1. All scripts can only be used for calibrating SDG products. 2. Updating SDG’s firmware to the newest version is strongly recommended. 3. Before being calibrated, all devices should have been operating continuously for more than 30 minutes within specified operating temperature range (18℃ ~ 28℃) 4. Make sure all devices are well connected as section 1.3 shows. 5. Don’t open Microsoft Office Excel when running scripts. --- End quote --- Recovery files on standby if you stuff it up ! :P |
| gman76:
Thanks tv84 and tautech. Using the sds2000 version worked. As I said before, the model numbers are confusing. It's now running 1.2.2.1R9. Now my other scope is back at rev 1.1.1.37.2, and it's been 2 yrs since I moved the one scope from V1 to V2, don't remember exactly. I need some help. When I go to Utility -> Update -> Config and select the sds2000.cfg with the Universal Knob then push it in, you can see that it's not recognizing the file. The menu at the bottom doesn't show a Load button. |
| tautech:
--- Quote from: gman76 on June 23, 2020, 11:34:56 pm ---Thanks tv84 and tautech. Using the sds2000 version worked. As I said before, the model numbers are confusing. It's now running 1.2.2.1R9. Now my other scope is back at rev 1.1.1.37.2, and it's been 2 yrs since I moved the one scope from V1 to V2, don't remember exactly. I need some help. When I go to Utility -> Update -> Config and select the sds2000.cfg with the Universal Knob then push it in, you can see that it's not recognizing the file. The menu at the bottom doesn't show a Load button. --- End quote --- V1 to V2 instructions attached. |
| tv84:
I'm revisiting these old Siglent firmwares to enable the BW upgrade. (Siglent disabled it intentionally.) The SHS has been successfully tested. The SDS are waiting for volunteers. If anyone wants to try an upgrade pm me. |
| Navigation |
| Message Index |
| Next page |
| Previous page |