Products > Test Equipment
Siglent .ads firmware file format
gman76:
Tautech, thanks - I checked both scopes. V2 scope can go to 70Mpts and V1 scope can do 14Mpts (not 35M, not 28M). This seems to confirm ver2 vs ver1.
I noticed that the Utility screen has a 'back' softkey option on V2 and is missing that softkey on V1. V1 never displays the 'Load' softkey, so it seems I can't even revert the fw. Ugh. But then I accidentally hit the Save/Recall button and changed one of the menus, then more softkeys appeared! OMG. Now I see the Load softkey. Now we're getting somewhere. I tried Utility>Configure> then menu popped up, pointed to .cfg file, hit Load softkey, and the scope does nothing, just beeps. WTH.
Is there some sort of master reset?
tautech:
--- Quote from: gman76 on June 26, 2020, 05:26:25 pm ---Tautech, thanks - I checked both scopes. V2 scope can go to 70Mpts and V1 scope can do 14Mpts (not 35M, not 28M). This seems to confirm ver2 vs ver1.
I noticed that the Utility screen has a 'back' softkey option on V2 and is missing that softkey on V1. V1 never displays the 'Load' softkey, so it seems I can't even revert the fw. Ugh. But then I accidentally hit the Save/Recall button and changed one of the menus, then more softkeys appeared! OMG. Now I see the Load softkey. Now we're getting somewhere. I tried Utility>Configure> then menu popped up, pointed to .cfg file, hit Load softkey, and the scope does nothing, just beeps. WTH.
Is there some sort of master reset?
--- End quote ---
From my quoted post from 2015:
First install a .cfg, then reboot.
Then the .ads file TWICE with a reboot after each install.
Finally a Self cal.
Step by step, follow this exactly ^^
gman76:
tautech, yes I know the steps but the scope doesn't behave as it should. When I push in the universal knob to select the cfg file, it just beeps and does nothing else. So, it seems I'm stuck. Is there another method to use? Update over ethernet?
tautech:
--- Quote from: gman76 on June 26, 2020, 09:57:43 pm ---tautech, yes I know the steps but the scope doesn't behave as it should. When I push in the universal knob to select the cfg file, it just beeps and does nothing else. So, it seems I'm stuck. Is there another method to use? Update over ethernet?
--- End quote ---
OK. What about the reboot ? How are you doing that ? Soft power button or hard OFF ?
tv84:
Look at this thread:
https://www.eevblog.com/forum/testgear/siglent_s-new-product-msosds2000-series/msg755017/#msg755017
I think you must press the "default" button to be able to load the .CFG.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version