Products > Test Equipment
Siglent - do SCPI commands for key strokes or the rotary encoder exist?
(1/2) > >>
EE-digger:
Specifically for Siglent SVA or SNA but of possible use to all instruments.

I've been creating SCPI scripts for functions that either don't exist or for convenience.  It would be more than handy if there were SCPI commands for key strokes or especially for knob rotation.  Yes, you can program most functions but a knob[nn|up|down] would work when the focus is on any field that takes knob entry, saving tons of work.

Any such commands out there ??
Tjuurko:
Look in file "SDG_Programming Guide_PG02-E05C.pdf" section "3.36  Virtual Key Command"
https://siglentna.com/download/16164/?tmstv=1728754057

This command works since SDM3065X.
It might work with SVA or SNA too.
EE-digger:
Thank you.  Very interesting.  I'll give it a shot with some of their examples and syntax.
tautech:
Programming manual specific to SVA and SSA analyzers:
https://siglentna.com/wp-content/uploads/dlm_uploads/2019/09/ProgrammingGuide_PG0703P_E02B.pdf
EE-digger:
I have the SNA programming manual but did not see any references at all to keys, knobs, virtual keys.

Also, tried some commands (knob and up, down related) from the other post and while they "succeed", they don't appear to do anything.
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod