Products > Test Equipment

Siglent SAG1021I AWG questions

(1/2) > >>

ninevoltz:
I've got an SAG1021I waveform generator I use with my SDS1204X-E, and I have a couple of questions. First, what does the AUX jack do? There is no manual for this thing anywhere. Second, how do you load waveforms onto it with EasyWaveX? I've installed all of the VISA/IVI drivers, and it appears in NI-MAX when I plug it into my PC, but EasyWaveX refuses to connect to it. What could I be doing wrong here? Siglent would not answer my request for support.

tautech:

--- Quote from: ninevoltz on September 21, 2023, 02:51:41 pm ---I've got an SAG1021I waveform generator I use with my SDS1204X-E, and I have a couple of questions.
--- End quote ---
Got one out especially.

--- Quote ---First, what does the AUX jack do?
--- End quote ---
Provides an I/O to sync other devices with.
Connect a BNC to a spare channel and observe its behavior when you output waveforms.

--- Quote ---There is no manual for this thing anywhere.
--- End quote ---

Most of what you need is in the SDS1004X-E datasheet and manual starting from P186.
https://int.siglent.com/u_file/document/SDS1000X_E_SDS1000X_U_UserManual_EN.pdf

--- Quote ---Second, how do you load waveforms onto it with EasyWaveX?
--- End quote ---
Described in the section: Stored Arb on P188

--- Quote ---I've installed all of the VISA/IVI drivers, and it appears in NI-MAX when I plug it into my PC, but EasyWaveX refuses to connect to it. What could I be doing wrong here?
--- End quote ---
EasyWaveX is a Windows utility and configured for direct connection to standalone AWG or to your DSO to which you send a Stored Arb as mentioned above.

Some crashing around in the DSO's SAG1021I menu, screenshots attached.

ninevoltz:
Thanks for the reply! I'll try it out next time I fire up my scope.

electr_peter:
Few questions on SAG1021I
1) Are there firmware updates for this module? Couldn't find any resources online.
2) Label on SAG1021I says "50MHz 125MSa/s". SDS800X HD wavegen & bode plot seems to limit max freq to 25MHz (SDS800X HD manual also mentions 25MHz). Is 25MHz max frequency limit in combination with SDS800X HD?

tautech:

--- Quote from: electr_peter on August 30, 2024, 10:20:35 am ---Few questions on SAG1021I
1) Are there firmware updates for this module? Couldn't find any resources online.
2) Label on SAG1021I says "50MHz 125MSa/s". SDS800X HD wavegen & bode plot seems to limit max freq to 25MHz (SDS800X HD manual also mentions 25MHz). Is 25MHz max frequency limit in combination with SDS800X HD?

--- End quote ---
1. Yes.
Dependant on the DSO series you need use it with.

2. Yes however some Siglent DSO's support SAG1021I use to 50 MHz, eg SDS3000X HD models.

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod