Products > Test Equipment
Siglent SDG1000 (aka LeCroy WaveStation) firmware updates
<< < (16/23) > >>
tautech:

--- Quote from: Fennec on December 07, 2014, 05:16:55 pm ---Here it is

--- End quote ---
Fennec, does it need to be unzipped or just have the file extension .zip removed?
Best to be clear about this.  :-+
ivan747:
Viewed the file in a hex viewer... it most likely needs unzipping. The hex of the unzipped file makes sense, it has some blocks of empty memory and some sort of binary structures on it. The zip file looks so random it might as well be used as a noise source.
tautech:

--- Quote from: ivan747 on December 09, 2014, 04:27:38 am ---Viewed the file in a hex viewer... it most likely needs unzipping. The hex of the unzipped file makes sense, it has some blocks of empty memory and some sort of binary structures on it. The zip file looks so random it might as well be used as a noise source.

--- End quote ---
I don't think this is the case. I believe Fennec probably added the .zip extension to allow uploading to this forum.
The .ADS extension is not permitted to be uploaded here, but is correct for a Siglent firmware file that have been unzipped.
However it is best to wait for confirmation.
miguelvp:
Just because I was curious I downloaded and it unzips fine to a 1,034,700 bytes long file.
So it's Zipped.
Fennec:

--- Quote ---Fennec, does it need to be unzipped or just have the file extension .zip removed?

--- End quote ---

Hi,

yes you have to unzip the file. Sry for the bad filename.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod