Products > Test Equipment
Siglent SDG1032 as bad as rigol DG812?
<< < (11/28) > >>
eTobey:

--- Quote from: Mortymore on May 18, 2024, 07:29:08 pm ---
Only one feedthrough 50Ohm terminator was used at CH1 of the scope, were the square wave was applied.

--- End quote ---

Which one exactly?
Mortymore:

--- Quote from: eTobey on May 18, 2024, 08:29:56 pm ---
--- Quote from: Mortymore on May 18, 2024, 07:29:08 pm ---
Only one feedthrough 50Ohm terminator was used at CH1 of the scope, were the square wave was applied.

--- End quote ---

Which one exactly?

--- End quote ---

The terminator? No brand. Does it matter for a low frequency signal?
eTobey:

--- Quote from: Mortymore on May 18, 2024, 08:36:57 pm ---
--- Quote from: eTobey on May 18, 2024, 08:29:56 pm ---
--- Quote from: Mortymore on May 18, 2024, 07:29:08 pm ---
Only one feedthrough 50Ohm terminator was used at CH1 of the scope, were the square wave was applied.

--- End quote ---

Which one exactly?

--- End quote ---

The terminator? No brand. Does it matter for a low frequency signal?

--- End quote ---

Probably not, but i might want to buy one ;-)
Aldo22:

--- Quote from: eTobey on May 18, 2024, 09:14:39 pm ---Probably not, but i might want to buy one ;-)

--- End quote ---

You can make one yourself to start with.
I made one from 2x100Ω  SMD.
Certainly not perfect, but much better than without (attached images).
Or something like this: https://de.aliexpress.com/item/1005005986180797.html
KungFuJosh:
I have a couple Rigol ADP0150BNC. Which will probably be the only Rigol gear I ever own. 🤣
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod