Products > Test Equipment

Siglent SDG1032 as bad as rigol DG812?

<< < (20/28) > >>

rf-loop:

--- Quote from: eTobey on May 21, 2024, 11:36:51 am ---
--- Quote from: rf-loop on May 21, 2024, 11:32:57 am ---This was a great find. Absolutely stunning and so true...

--- End quote ---

Dont you want to post a screen shot of a comparable test?


--- End quote ---

If I have extra time, I'd rather play with my own grandchildrens than yours. If you think it's discriminatory, file a discrimination complaint.  :/

TurboTom:

--- Quote from: eTobey on May 21, 2024, 10:47:21 am ---Just found out, that the squarewave has a glitch (seemingly) when starting with the enable button.
The first low pulse is not as the duty is set up. The length of the low pulse is longer with different deviations.

200mHz
0-3.3V
99% duty
50 Ohm
Channel 1

--- End quote ---

Relay bounce? That would be something to expect, present on all AWGs that I'm aware of that provide complete galvanic isolation of the outputs in disabled condition.

eTobey:

--- Quote from: TurboTom on May 21, 2024, 01:37:42 pm ---
--- Quote from: eTobey on May 21, 2024, 10:47:21 am ---Just found out, that the squarewave has a glitch (seemingly) when starting with the enable button.
The first low pulse is not as the duty is set up. The length of the low pulse is longer with different deviations.

200mHz
0-3.3V
99% duty
50 Ohm
Channel 1

--- End quote ---

Relay bounce? That would be something to expect, present on all AWGs that I'm aware of that provide complete galvanic isolation of the outputs in disabled condition.

--- End quote ---

Show me a relay, that has a bounce after 5 seconds ;-)

Fgrir:

--- Quote from: eTobey on May 21, 2024, 10:47:21 am ---Just found out, that the squarewave has a glitch (seemingly) when starting with the enable button.
The first low pulse is not as the duty is set up. The length of the low pulse is longer with different deviations.

200mHz
0-3.3V
99% duty
50 Ohm
Channel 1

--- End quote ---
I see a similar effect on an SDG2042X - seems like the first cycle is running with a random falling edge.

Martin72:

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod