| Products > Test Equipment |
| Siglent SDG1032 as bad as rigol DG812? |
| (1/28) > >> |
| eTobey:
Found some issues that dissapointed me quite a bit. Never thought i would be that dissapointed, since the step from the Rigol DHO814 to the Siglent SDS814X HD was a good one. Some issues on my list have not been fixed in 7 years (as they can be found in an old youtube video). - Turning the knob faster, has the opposite effect of slowing down the change in the number, to almost non at all. - Turning it in the right speed takes still 13 seconds to get from 0 to 100. - Low level of -560mV for 5.3ms when changing waveform from sine to square - Changing values of 100´s down to zero and back up again changes the cursor to 1´s... - Changing the frequency of one channel, disrupts signal of other channel. - Polarity invert changes waveform to negative values, even when lowlevel is set to 0V. |
| 2N3055:
--- Quote from: eTobey on May 16, 2024, 07:11:21 am ---Found some issues that dissapointed me quite a bit. Never thought i would be that dissapointed, since the step from the Rigol DHO814 to the Siglent SDS814X HD was a good one. Some issues on my list have not been fixed in 7 years (as they can be found in an old youtube video). - Turning the knob faster, has the opposite effect of slowing down the change in the number, to almost non at all. - Turning it in the right speed takes still 13 seconds to get from 0 to 100. - Low level of -560mV for 5.3ms when changing waveform from sine to square - Changing values of 100´s down to zero and back up again changes the cursor to 1´s... - Changing the frequency of one channel, disrupts signal of other channel. - Polarity invert changes waveform to negative values, even when lowlevel is set to 0V. - Maximum Amplitude output setting ALL settings lost after reboot. --- End quote --- |O |O |
| tautech:
--- Quote from: eTobey on May 16, 2024, 07:11:21 am ---ALL settings lost after reboot. --- End quote --- :-DD Boot to Default is the default setting. Boot to Last saves all settings. ^^^ something we set before dispatch. ;) |
| eTobey:
--- Quote from: tautech on May 16, 2024, 07:47:21 am --- --- Quote from: eTobey on May 16, 2024, 07:11:21 am ---ALL settings lost after reboot. --- End quote --- :-DD Boot to Default is the default setting. Boot to Last saves all settings. ^^^ something we set before dispatch. ;) --- End quote --- I set that too, but the firmwareupdate reset it. Should have checked... |
| eTobey:
Lucky me, i havent hooked up my circuit yet: Set up a square wave from 0V to 3.3V. Set up FM mod -> boom! -1.6V :-BROKE |
| Navigation |
| Message Index |
| Next page |