Products > Test Equipment

Siglent SDG1032 as bad as rigol DG812?

(1/28) > >>

eTobey:
Found some issues that dissapointed me quite a bit. Never thought i would be that dissapointed, since the step from the Rigol DHO814 to the Siglent SDS814X HD was a good one.

Some issues on my list have not been fixed in 7 years (as they can be found in an old youtube video).

- Turning the knob faster, has the opposite effect of slowing down the change in the number, to almost non at all.
   - Turning it in the right speed takes still 13 seconds to get from 0 to 100.
   
- Low level of -560mV for 5.3ms when changing waveform from sine to square
- Changing values of 100´s down to zero and back up again changes the cursor to 1´s...
- Changing the frequency of one channel, disrupts signal of other channel.
- Polarity invert changes waveform to negative values, even when lowlevel is set to 0V.

2N3055:

--- Quote from: eTobey on May 16, 2024, 07:11:21 am ---Found some issues that dissapointed me quite a bit. Never thought i would be that dissapointed, since the step from the Rigol DHO814 to the Siglent SDS814X HD was a good one.

Some issues on my list have not been fixed in 7 years (as they can be found in an old youtube video).

- Turning the knob faster, has the opposite effect of slowing down the change in the number, to almost non at all.
   - Turning it in the right speed takes still 13 seconds to get from 0 to 100.
   
- Low level of -560mV for 5.3ms when changing waveform from sine to square
- Changing values of 100´s down to zero and back up again changes the cursor to 1´s...
- Changing the frequency of one channel, disrupts signal of other channel.
- Polarity invert changes waveform to negative values, even when lowlevel is set to 0V.
- Maximum Amplitude output setting ALL settings lost after reboot.

--- End quote ---

 |O |O

tautech:

--- Quote from: eTobey on May 16, 2024, 07:11:21 am ---ALL settings lost after reboot.

--- End quote ---
:-DD
Boot to Default is the default setting.
Boot to Last saves all settings.


^^^ something we set before dispatch.  ;)

eTobey:

--- Quote from: tautech on May 16, 2024, 07:47:21 am ---
--- Quote from: eTobey on May 16, 2024, 07:11:21 am ---ALL settings lost after reboot.

--- End quote ---
:-DD
Boot to Default is the default setting.
Boot to Last saves all settings.


^^^ something we set before dispatch.  ;)

--- End quote ---
I set that too, but the firmwareupdate reset it. Should have checked...

eTobey:
Lucky me, i havent hooked up my circuit yet:
Set up a square wave  from 0V to 3.3V. Set up FM mod ->  boom! -1.6V  :-BROKE

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod