| Products > Test Equipment |
| Siglent SDG1032 high level limited to low ... |
| (1/6) > >> |
| eTobey:
Hi, i had a go before, but i guess i am missing something? I have set up amplitude limit to 6.6Vpp. But when setting the low level to 0V and the high level to 3.3V, it does limit to level to 1.65V. I have also tried with higher amplitude limit, and it does work above 1.65V. But this limiting looks wrong to be. The load is 50 Ohm, and so is the setting of the load in the device. |
| KungFuJosh:
You should stop creating threads for questions about gear that already has threads. You should post this question in the SDG1032 main thread. |
| Fgrir:
Is your output in 50 ohm load mode? I think the amplitude limit is always based on the unloaded voltage, so with 50 ohm the output limit will be half of what you set. |
| tautech:
--- Quote from: Fgrir on May 24, 2024, 01:49:33 pm ---Is your output in 50 ohm load mode? I think the amplitude limit is always based on the unloaded voltage, so with 50 ohm the output limit will be half of what you set. --- End quote --- Most likely quite correct, :-+ however as is usual the full setup details are never shared. ::) |
| eTobey:
--- Quote from: Fgrir on May 24, 2024, 01:49:33 pm ---Is your output in 50 ohm load mode? I think the amplitude limit is always based on the unloaded voltage, so with 50 ohm the output limit will be half of what you set. --- End quote --- Sorry, i forgot to mention that i have a 50 Ohm load, and that i have set up the load as 50 Ohm. |
| Navigation |
| Message Index |
| Next page |