Products > Test Equipment

Siglent SDG2000X Firmware, Hardware, Software Versions

<< < (8/8)

tautech:

--- Quote from: alocam on November 26, 2024, 12:54:34 am ---Thank you for your reply. As usual, your help is highly appreciated!
Should I go ahead and upgrade to the latest release with no intermediate steps? Does it take care of any HW compatibility issues?
Regards,

--- End quote ---
Study the Compatibility between Versions list in the PDF.  ;)

alocam:
Thank you again. I have had a look at the pdf, but it is somehow confusing. I understand that since I am at 23R8, I can immediately upgrade to 35R3B1 with no apparent issues.
However, it is not clear whether I can then jump to 35R3B2->37R3->R6->R8->38R4, or whether the warnings for 37R3 (compatible with F hardware) or 37R6 (compatible with G hardware) are a show stopper and I'd rather stay with R3B2.
Sorry about being redundant, I am willing to update this unit but I would hate to brick it...
Any suggestions will be welcome.

PS: Just in case it helps, I decided to go ahead and try upgrading in steps, so I went through three or four of the pending upgrades, just in case I receive any hardware incompatibility warning, but it looks like everything went fine, now I am running 38R4 with no apparent issues.

Regards!

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod