Products > Test Equipment

Siglent SDL 1020X-E DC Electronic Load - Analog Monitor Outputs

(1/2) > >>

zburmeister:
Hello,

I have been working with the Siglent SDL 1020X-E Electronic Load for a bit and so far so good.  However, I have not been able to get the analog monitor outputs for current and voltage to work on the rear of the unit.  I have connected both outputs to an oscilloscope yet there is no activity on the lines.  I have also looked extensively through the unit's settings but have not found a configuration to enable/disable the ports.  Perhaps it's a firmware issue, perhaps it's a bad device.  Does anyone have any advice? Thanks!

Here is a link to the user manual.  Items 9 and 10 on page 17 are the two ports I am referring to above. http://siglentna.com/wp-content/uploads/dlm_uploads/2019/04/SDL1000X_UserManual_UM0801X-E01A.pdf

tv84:
Why didn't you make the question in the Siglent SDL 1020X-E thread?  :-//

zburmeister:
Not sure what is wrong with posting where I did? If you could point me to the right place that would be great.  Thanks!

tautech:

--- Quote from: zburmeister on September 24, 2021, 09:49:40 pm ---Not sure what is wrong with posting where I did? If you could point me to the right place that would be great.  Thanks!

--- End quote ---
Not too much however it ends up cleaner for everyone if everything is in one thread.
https://www.eevblog.com/forum/testgear/siglent-sdl1000xsdl1000x-e-electronic-load/

BTW welcome to EEVblog.

zburmeister:
Thanks, and sounds good. I didn't realize it was preferred to tag onto a generic thread as opposed to a standalone one.  8)
Is there a place I can close/remove this thread?

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod