Siglent SDL 1020X-E DC Electronic Load - Analog Monitor Outputs

[zburmeister]

Hello,

I have been working with the Siglent SDL 1020X-E Electronic Load for a bit and so far so good.  However, I have not been able to get the analog monitor outputs for current and voltage to work on the rear of the unit.  I have connected both outputs to an oscilloscope yet there is no activity on the lines.  I have also looked extensively through the unit's settings but have not found a configuration to enable/disable the ports.  Perhaps it's a firmware issue, perhaps it's a bad device.  Does anyone have any advice? Thanks!

Here is a link to the user manual.  Items 9 and 10 on page 17 are the two ports I am referring to above. http://siglentna.com/wp-content/uploads/dlm_uploads/2019/04/SDL1000X_UserManual_UM0801X-E01A.pdf

[tv84]

Why didn't you make the question in the Siglent SDL 1020X-E thread? 

[zburmeister]

Not sure what is wrong with posting where I did? If you could point me to the right place that would be great.  Thanks!

[tautech]

Not sure what is wrong with posting where I did? If you could point me to the right place that would be great.  Thanks!

Not too much however it ends up cleaner for everyone if everything is in one thread.
https://www.eevblog.com/forum/testgear/siglent-sdl1000xsdl1000x-e-electronic-load/

BTW welcome to EEVblog.

[zburmeister]

Thanks, and sounds good. I didn't realize it was preferred to tag onto a generic thread as opposed to a standalone one. 
Is there a place I can close/remove this thread?

[Smokey]

Here is the link to this discussion in the other thread and the answer to the question:

https://www.eevblog.com/forum/testgear/siglent-sdl1000xsdl1000x-e-electronic-load/msg3709318/#msg3709318

It's a bit hidden: Utility -> Config -> EXTC -> I_M_ON AND V_M_ON

Manual:
https://int.siglent.com/upload_file/user/SDL1000X/SDL1000X_UserManual_UM0801X-E01A.pdf
Chapter 3 System Utility Function P69 > Set EXTC (External Interface) P81