Products > Test Equipment

Siglent SDL1000X/SDL1000X-E Electronic Load

<< < (73/85) > >>

Martin72:
Hi,
There are no schematics in the service manual, only some measure points.

pmendiuk:
Sounds like I'll be making some schematics for the output circuit and the FET drivers.  Has anyone done their own calibration for the SDL1020X-E?

Martin72:
I got the SM today, I have to read through the calibration part first.

Martin72:
Here the service manual(will be deleted within 24hrs):
(Link removed)

Martin72:
I couldn't hold back any longer and tried to see if I could turn the 1020X-E into a 1030X load.
It works, and it's very quick and easy... ;)
I used LAN instead of the USB connection.

And then as follows:
-Select LAN as the connection on the load, activate DHCP
-Call up Putty (or a similar program)
-Enter the assigned IP, port 5025, Telnet
-Then enter the known commands in the Putty window(I only entered them separately because of the pictures, you can of course type them in one after the other and confirm with Return.)
-There is no feedback, disconnect afterwards and switch off the load.
-Switch the load on again and be happy.  8)

The calibration should therefore be invalid, I will recalibrate it soon.

Martin

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod