Products > Test Equipment

Siglent SDL1000X/SDL1000X-E Electronic Load

<< < (85/85)

Tjuurko:
Any power supply with an output voltage of 0...1V and current 2A. The assembly of 10 capacitors 2200 μF is connected to the power supply.
SDL1020X-E is connected to the assembly of capacitors with thick wires (2x1 meter 10AWG).
By adjusting the voltage at the output of the power supply, this effect can be achieved.

This effect is achieved only in the area of ​​small low voltage.

Martin72:
This makes sense because you are charging the capacitors, which absorb more current when the voltage rises.
You should also have the same effect when using a normal load resistor.

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod