Products > Test Equipment
Siglent SDM3045X - Enough is enough
et328:
--- Quote from: Pinkus on January 14, 2022, 09:43:59 am ---My XML files are probably useless, as if you open them, you will see no information about the model number, thus it has to be stored somewhere else.
--- End quote ---
I think tv84 asked for file named NSP_system_info.xml and that was not in your zip. How do you access your 3045's file system? (I haven't connected it to usb or network.)
Ringmodulator:
--- Quote from: et328 on January 14, 2022, 09:47:03 am ---
--- Quote from: Pinkus on January 14, 2022, 09:43:59 am ---My XML files are probably useless, as if you open them, you will see no information about the model number, thus it has to be stored somewhere else.
--- End quote ---
I think tv84 asked for file named NSP_system_info.xml and that was not in your zip. How do you access your 3045's file system? (I haven't connected it to usb or network.)
--- End quote ---
See my post in the main SDM thread:
https://www.eevblog.com/forum/testgear/siglent-new-bench-dmm-sdm3055/msg3346192/#msg3346192
There is also the info on how to backup the calibration data.
Credit for the ADS file is due to tv84 :-+
Chris
Pinkus:
OK, here are the files from the other directory including NSP_system_info.xml.
Though there is just a serial # in there (I changed the last numbers into '0' as probably not important).
This Zip also includes the calibration data. It shows that indeed the calibration borders are "2" and not "6", thus there should be no problem by using the 3055x-e firmware.
tv84:
--- Quote from: Pinkus on January 14, 2022, 04:07:30 pm ---OK, here are the files from the other directory including NSP_system_info.xml.
Though there is just a serial # in there (I changed the last numbers into '0' as probably not important).
This Zip also includes the calibration data. It shows that indeed the calibration borders are "2" and not "6", thus there should be no problem by using the 3055x-e firmware.
--- End quote ---
Exactly. Thanks for sharing.
So, the the model name needs to be changed in the NSP_trends_config_info.xml.
To be totally correct it would be good to see this file content in an official 3055X-E.
dl6lr:
--- Quote from: tautech on January 14, 2022, 06:24:29 am ---That's what some browsers do. >:(
--- End quote ---
No, the redirect is what the server sends. This may be based on UserAgent settings or similar, but it is never a browser decision. The browser decision is to either display the error or follow the redirect. You can clearly see this in my wget trace.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version