Products > Test Equipment

Siglent SDM3065X Multimeter won't boot.

<< < (3/5) > >>

ScottW:
Had this same issue today, 3065X would not go past boot screen.  Like the OP, this was after a long period (months?) of not being powered on.

Contacted Rob / Tautech, and he had me all fixed up super fast!!!  Now booted up and have updated to the latest firmware, everything looking good.

So, a big shout out and THANK YOU to Rob!  Absolutely fantastic to have him here helping us out!

Wilmer Samaniego:
Hi friend, I have the same problem with the Siglent SDM3065X multimeter, it gets stuck on the logo and I think it needs firmware recovery, maybe you can help me with this file or a link to contact Siglent support. Thank you very much.

coromonadalix:
ask Tautech member  he normally help locked or un-bootable units...  if its in his power  ...   :-+

tautech:

--- Quote from: Wilmer Samaniego on October 02, 2024, 06:13:28 pm ---Hi friend, I have the same problem with the Siglent SDM3065X multimeter, it gets stuck on the logo and I think it needs firmware recovery, maybe you can help me with this file or a link to contact Siglent support. Thank you very much.

--- End quote ---
Welcome to the forum.

Check your messages.

MaKe68:
Hi,

I just ran into the same issue. Haven't used my SDM3065X since a few months and now there is only the boot screen when switching on. I have installed the most recent firmware update several months ago and it worked after that without any issue. However, since then it was sitting unused on my bench for a couple of months and today does not start anymore. If I understand correct from this thread there is a firmware fix available - at least as a first option to bring back the device normal live ... is there a link to that firmware or how can I eventually get a copy of that firmware? Any advice appreciated. Thanks.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod